Connecting Stereo Mix 1U to the Audio Jacks on your 7U Case
If you have a 2nd generation Audio Jacks board installed in your Intellijel 7U Performance Case,
you can connect one or two Stereo Mixer 1U’s directly to these jacks. This connection method does
not work with a 1st generation Audio Jacks board, though you can purchase and easily install a 2nd
generation board in your case.
You can distinguish 1st generation boards (included with cases built before early 2019) by the
single connector along the bottom of the Audio Jacks board. 2nd generation boards have a large
shrouded header flanked by two smaller shrouded headers, flanked by two link connectors.
Output Connection
1.
Connect one end of the supplied 3-wire link cable to the
CHAIN-OUT
on your Stereo Mixer 1U.
2.
Connect the other end to either of the two 3-pin connectors
on the Audio Jacks board. The left connector uses the two
left jacks for L/R Stereo outputs, while the right connector
uses the two right jacks.
In this scenario, the audio jacks work as unbalanced
outputs.
Stereo Mixer 1U Manual
9
