Connecting Mixup Directly to the Audio Jacks on your 7U Case
If you have a 2nd generation Audio Jacks board installed in your Intellijel 7U Performance Case,
you can connect one or two Mixups directly to these jacks. This connection method does not work
with a 1st generation Audio Jacks board, though you can purchase and easily install a 2nd
generation board in your case.
You can distinguish 1st generation boards (included with cases built before early 2019) by the
single connector along the bottom of the Audio Jacks board. 2nd generation boards have a large
shrouded header flanked by two smaller shrouded headers, flanked by two link connectors.
To Connect the Mixup to a 2nd Generation Audio Jacks board:
1.
Connect one end of the
supplied 3-wire Lnk cable into
the
CHAIN-OUT
on your
Mixup.
2.
Connect the other end to
either of the two 3-pin Link
connectors on the Audio
Jacks board. The left
connector uses the two left
jacks for L/R Stereo outputs,
while the right connector uses
the two right jacks.
In this scenario, the audio
jacks work as unbalanced
outputs.
Mixup Manual
10
