ViewFlex Ca mera Assembl y Ins tructions
6
© 2019 Intelitek - Al l Rights Reserved
2.
Wiring the Power Connections
You Cognex vision sens
or’s
breakout cable requires connection to a 24VDC adapter before it can be
connected to the power supply unit.
Note:
For this procedure, you require a small flat-head screwdriver.
To wire the breakout cable:
1.
Locate and separate the black and red wires at the end of the breakout cable. The black wire is
the ground connection and the red wire is the +24VDC connection. For information about the
other wires in the breakout cable, see the appendix.
2.
Connect the black and red wires to the adapter, using the screwdriver to secure the wires:
▪
Connect the black wire to the adapter’s (-) slot.
▪
Connect the red wire to the adapter’s (+) slot.
Note:
Unused wires can be clipped short or tied back using a tie made of non-conductive
material. Keep all bare wires separated from the +24VDC wire.
3.
Connect the adapter to the power supply.
4.
Connect the power supply to a wall adapter.
5.
Ensure that the vision sensor’s green power LED is lit.
