3 Installing the Hardware and Software
3.1 Preparing for Installation
16
3.1.4.
Unpacking and Setting up the Milling Center
Follow this procedure for unpacking and setting up the milling center.
Procedure: Unpacking and Setting up the Milling Center
1.
Position the pallet near the location at which you'll set the milling center.
2.
Remove the staples that attach the bottom of the cardboard container to the pallet.
3.
Cut the banding around the container.
4.
Lift the cardboard cover off the top of the container.
5.
Remove the sides of the container.
6.
Inspect the milling center chassis for signs of visual damage such as a broken shield, a dent in the chassis,
or damaged cables.
7.
Call Intelitek Customer Support if any damage is noted.
8.
Remove the four bolts that hold the milling center base to the pallet, using a 19mm wrench.
9.
Store the bolts and other packaging materials, in case the product has to be returned or transported.
10.
Lift the milling center off of the pallet and place it at its designated location.
11.
Position the milling center correctly for milling.
12.
Remove the protective paper from the safety door.
13.
Open the front door and remove the components from the enclosure.
0
.
3.1.5.
Checking your Shipment
Follow this procedure for checking your shipment once unpacked.
Procedure: Checking your Shipment
1.
Locate the packing slip. This slip lists all of the items you should have received with your milling center.
2.
Check that all items on the packing slip are present. See the checklist below.
3.
Contact Intelitek Customer Support immediately if any item is missing.
0
.
Use this checklist to ensure that all items listed on the packing slip are present in the delivery.
Checklist: Checking your Shipment
No.
Item
1
ProMill 8000 Milling Center
2
Installation disk for CNCBase/Motion software
3
Documentation pack
Take Note
