Intelbras IVP 3021 SHIELD, Руководство пользователя

Страница: 6 / 8

6
4. Installation
Open the front cover of the sensor (pressing the sides), make a hole in the back of the box for the passage of the power
and alarm wires. Connect the power to terminal J1 (+12 V) obeying the polarity. Connect the alarm wires to terminal J2.
The IVP 3021 SHIELD does not need to be installed with an articulator, as it already has a 15 ° tilt angle. Its scanning angle
is 115º and the range is up to 12 meters.
Important: The IVP 3021 SHIELD is designed for indoor and closed areas, so do not use it for protecting outdoor or open
areas.
5. Configuration
After installation, put the cover on and connect the sensor to the power supply. The led will be flashing for ± 35 to 40
seconds (stabilization time and self test), when it goes out, the sensor will be in normal operation.
Walk slowly in front of the sensor observing if the led lights up in the entire area that needs to be protected, if necessary
readjust the position of the sensor. If the alarm panel used is Intelbras, put it in the test mode, this way it will not be neces-
sary to observe the led, as the panel will indicate the functioning of the sensor through siren beeps.
The jumper (JP1) controls the pulse count to trigger the alarm. With the jumper in position (1 and 2) the sensor provides
maximum sensitivity. With the jumper in position (2 and 3) the sensor provides minimum sensitivity, i.e. detection suitable
for environments with high incidence of EMI and RFI interference. Factory default: Jumper in position (2 and 3).