Intelbras IVP 3000 CF, Руководство пользователя

Страница: 6 / 8

6
5. Configuration
After installation, put the cover on and connect the sensor to the power supply. The LED will flash for + - 35 to 40 seconds (sta-
bilization time and self-test), when it goes out, the sensor will be in normal operation.
Walk slowly in front of the sensor observing if the led lights up throughout the area that needs to be protected, if necessary
readjustment the position of the sensor. If the alarm panel used is Intelbras, put it in the test mode, this way it will not be
necessary to observe the led, as the control panel will indicate the functioning of the sensor through siren beeps.
The JP1 jumper controls the detection sensitivity of the sensor. This one adjustment jumper has two selectable levels, with
the jumper on the position 1 the sensor provides maximum sensitivity, with the jumper on position 2 the sensor provides
minimum sensitivity, that is, detection suitable for environments with a high incidence of EMI and RFI interference.
Factory default: Jumper in position 2.
Sensitivity adjustment table
Position Condition
Maximum sensitivity
Minimum sensitivity
Whitout jumper Maximum sensitivity