Intel SR6850HW4 - Server Platform - 0 MB RAM, Руководство по эксплуатации продукта

Страница: 152 / 272

User Serviceable Platform Components
152 Intel® Server Platforms SR6850HW4 and SR6850HW4/M Product Guide
Installing a Hot-plug PCI Add-in Card
CAUTION
Only PCI add-in cards in PCI slots 1 through 5 are hot-swappable. If you are
adding or removing a PCI card from PCI slot 6 or 7, see “
Removing a Non-
Hot-Plug PCI Card ” on page 154, and “ Installing a Non-Hot-Plug PCI Card ”,
page 155.
1. Observe the safety precautions, warnings, and cautions described in “ Safety Information ”, page
5.
2. If your server is operating, use your operating system or GUI application to power down the
PCI slot.
3. Remove the top cover. For instructions, see “ Removing the Top Cover ”, page 139.
4. Being careful not to touch the components or gold edge-connectors on the add-in card, remove
the card from the anti-static bag, and place it on a clean, ESD-protected work surface.
5. Record the serial number of the board and any jumpers or switch settings according to the
board manufacturer’s instructions. See “
Equipment Log ”, page 252.
6. Push the retention latch at the rear of the card slot to open it. See letter “A” in Figure 73.
7. If necessary, remove the expansion slot cover in the slot you are using by sliding it up from
inside the chassis. See letter “B” in the figure.
8. Align and slide the adapter board down until it seats in its connector. If you are installing a full-
length card, guide the front of the card into the slot shown by letter “D” in the figure.
9. Press the card down firmly until it seats into the slot.