Intel SR2600UR - Server System - 0 MB RAM, Руководство по обслуживанию

Страница: 129 / 234

Intel
®
Server System SR2600UR/SR2625UR Service Guide 109
Figure 102. Removing the Backplane from the Intel
®
Server System SR2625UR
Installing the Backplane
To install the backplane, follow these steps:
1. Remove the midplane board. For instructions, see “Removing the Midplane Board”
on page 102 .
2. Remove all hot-swap drive carriers, regardless of whether or not a drive is installed
in the carrier. For instructions, see “Removing a SAS or SATA Hot-swap Hard Disk
Drive” on page 74 .
3. Depending on your server system, do one of the following:
For Intel
®
Server System SR2600UR, do the following:
a. Hold the backplane only by the edges. Do not push or pull on any components on
the backplane. Set the backplane in place at the front of the server system, with
the sides of the board resting in the guides at the left and right sides of the server
system.
b. Slide the backplane into the server system guides at the left and right sides of the
server system until the pins at the left and right sides of the backplane bracket are
AF003110
A
C
B