Intel Server Board SE7501BR2
Installation and Integration Guide
Installing the Boxed Intel
Xeon
Processor - Intel SC5200
Chassis, Base version
Choosing the Processor Socket
Use these instructions for installing your processor instead of the instructions that came
with your boxed processor unless you are using the Hot-Swap Redundant Power version of
the Intel
SC5200 Server Chassis (see page 14 when installing in that chassis).
•
If only ONE processor is to be used, it must be installed in the processor socket
labeled CPU1, located closest to the corner of the server board. No processor
terminator is required on a single processor system. Do not install a terminator in the
SE7501BR2 Server Board.
•
If installing a SECOND processor, verify that the processors are identical in voltage
and speed. Do not mix processors of different types or frequencies.
•
To avoid touching the pins, hold the processor only by the edges when unpacking it.
Opening the Socket Lever
Open the lever all the way as shown. This server board has
“zero-insertion force” (ZIF) sockets. If the processor does not
drop easily into the socket holes, make sure the lever is in the
full-open position and the processor is oriented properly.
Applying pressure will damage the processor pins.
Attaching the Processor
1.
Align the alignment triangle mark on the
processor with the alignment triangle
cutout on the socket.
2.
Insert the processor in the socket.
3.
Close the socket lever all the way as
shown.
12
