Intel SC5650-DP, Руководство по обслуживанию

Страница: 36 / 174

Hardware Installations and Upgrades
18 Intel
®
Chassis SC5650-DP/WS/BRP/UP Service Guide
Installing the Front Bezel Assembly
1. Line up the three clips on the right side of the front bezel assembly with the
corresponding slots on the right side of the chassis (see letter “A” in the following
figure). Engage the clips with the slots (see letter “B”). Rotate the left side of the front
bezel assembly towards the chassis (see letter “C”). Snap the two bezel tabs into the
corresponding recesses at the left edge of the chassis front panel (see letter “D”).
Figure 14. Installing the Front Bezel Assembly (DP/WS/BRP configuration shown)
2. Reinstall the left side cover. For instructions, see “Installing the Left Side Cover” .
3. Reconnect all peripheral devices and the AC power cable. Power up the server.
Installing or Removing a Server Board
Note: The type of Intel
®
Server Board you can install in your chassis depends on the model of
chassis you purchased. For a breakout of server board/chassis model compatibility, see
Table 1, “Breakdown of Intel® Server Chassis SC5650 Configurations” .
To install or remove a server board, do the following:
1. Observe the safety and ESD precautions listed in Appendix A, “Safety Information” .
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the left side cover. For instructions, see “Removing the Left Side Cover” .
4. Remove the front bezel assembly. For instructions, see “Removing the Front Bezel
Assembly” .
TP02035
D
D
A
A
A
C
A
B