Intel® Server System S9200WK Product Family Setup and Service Guide
38
Figure 32
. 2.5”
drive carrier assembly
–
drive installation into the carrier
2.
Carefully unpack the new drive, taking care not to touch any of the connector pins located on the
back side of the drive.
3.
With the rear drive connector positioned toward the back of the drive carrier, align and position the
mounting holes on one side of the drive over the mounting tabs located on the drive carrier side rail
(see Letter A).
4.
Lower the other side of the drive into the carrier (see Letter B) and press down on the drive until all
mounting tabs are locked in place.
Figure 33
. 2.5” d
rive carrier assembly
–
alignment features
Note:
The 2.5” drive blank and drive carrier each have alignment features (shown in
) ensuring proper
assembly. When re-installing a drive blank into the drive carrier ensure the features are aligned prior to
installation, as failure to properly install a drive blank may result in the carrier assembly not fitting properly
into the drive bay.
