Intel R2000WT, Руководство по системной интеграции и обслуживанию

Страница: 59 / 140

Intel
®
Server System R2000WT Product Family System Integration and Service Guide
43
2.8.2 Mounting a Riser Card Option to the Riser Bracket
Depending on the system model, your server may or may not have all three riser cards installed. This section
describes the process of adding a riser card option to the riser bracket.
Figure 54. Riser Card Installation to Riser Bracket
• Remove the riser bracket from the chassis (see section 2.8.1)
•
Remove the fastener screw from the riser bracket (see letter ‘C’)
• Locate and remove the riser card option from its packaging
•
Place the riser card onto the bracket so that the three bracket pins fit into the matching key holes on the
riser card. (see letter ‘A’)
• Slide the riser card in the direction shown, locking the riser card to the bracket (see letter ‘B’)
•
Install the fastener screw to secure the riser card to the bracket. (see letter ‘C’)
2.8.3 PCI Add-in Card Installation
Figure 55. PCI Add-In Card Installation
•
Remove the PCI riser assembly from the system. (see section 2.8.1)
•
Remove the filler panel from the add-in card slot and remove the fastener screw as shown (see letter ‘A’)
• Insert the add-in card until it is fully seated inside the PCI slot on the riser card (see letter ‘B’)
•
Secure the add-in card to the riser bracket with the fastener screw as shown (see letter ‘C’)
NOTE: For add-in cards with internal cable connectors, it may be necessary to connect cables before
installing the riser card assembly into the system.