19
Installing a Hot-swap Storage Device
Note:
To maintain proper system cooling, all externally accessable drive bays must be
populated with a carrier mounted with a storage device (hard disk drive (HDD) or
Solid State Device (SSD)) or with a supplied drive blank.
3.5” Hard Disk Drive Assembly
1. Remove the drive carrier from the chassis by pressing the green button
and pulling open the lever (see letter
A
).
2. Pull the carrier out of the drive bay (see letter
B
).
Figure 27. 3.5” HDD Assembly – Removing the Carrier
3. Remove the four screws securing the plastic drive blank to the carrier.
4. Remove the drive blank from the carrier (see letter
C
).
Figure 28. 3.5” HDD Assembly – Removing the Drive Blank
TO
P
A
B
AF006699
AF004072
TO
P
BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
C