Programming the SPI Flash Firmware
Appendix C
Building an Intelligent Device
Platform Project Using Wind River
Workbench
This appendix provides step-by-step instructions to build a Wind River Intelligent
Device Platform project using Wind River Workbench. The steps below guide you
through tasks such as selecting configuration options and adding different layers to
your project.
This appendix assumes the following:
•
Your Host System is running Ubuntu 12.04, 64-bit.
•
You used the directory names indicated in
Section 5.3.1, Disk Space and
Section 6.1, Build Requirements
. If you used different
directory names, replace the directory names in the steps below with the
directories that you created.
•
You followed the instructions in
Section 6, Building the Intelligent Device
to install Intelligent Device Platform on your
Host System.
•
You know how to deploy a runtime image on your Target Device. See
Section
7, Installing Software on the Target Device
C.1
Create the Project
1.
Use the following commands to launch Workbench:
cd $HOME/WindRiver
./ startWorkbench.sh
Intel
®
Gateway Solutions for the IoT – Development Kit – DK50
October 2014
Getting Started Guide
Document Number: 330496-005
55