Appendix C Building an Intelligent Device Platform
Project Using Wind River
®
Workbench
This appendix provides step-by-step instructions to build a Wind River Intelligent
Device Platform project using Wind River Workbench. The steps below guide you
through tasks such as selecting configuration options and adding different layers to
your project.
This appendix assumes the following:
•
Your Host System is running Ubuntu 14.04, 64-bit.
•
You used the directory names indicated in
Create Directories and Confirm Disk
on page 26. If you used different directory names, replace the directory
names in the steps below with the directories that you created.
•
You followed the instructions in
Installing the Wind River Host Tools
•
You know how to deploy a runtime image on your Target Device. See
Intelligent Device Platform XT Runtime on Target Device
on page 47.
Note:
These steps will take 2 - 4 hours to complete.
Create the Project
1. Use the following commands to launch Workbench:
cd $HOME/WindRiver
./ startWorkbench.sh
2. Upon launching, Workbench asks for a workspace folder. Type the path or browse
to your workspace folder. Suggestion: Use your home folder. See the following
figure:
Figure 33.
Workspace Location Selection
Building an Intelligent Device Platform Project Using Wind River
®
Workbench—Intel IoT
Gateway Development Kit DK100 Series
Intel
®
IoT Gateway Development Kit DK100 Series
April 2015
Getting Started Guide
Order No.: 330307-007
55
