Embedded Intel® Atom™ Processor N2800 with Intel® NM10 Express Chipset Development Kit User‘s Manual
49
2.15.2.9
Standby Power Indicator LED
The standby power indicator LED shows that power is still present even when the
computer appears to be off. Figure 10 shows the location of the standby power LED.
CAUTION
If AC power has been switched off and the standby power indicator is still lit,
disconnect the power cord before installing or removing any devices connected to the
board. Failure to do so could damage the board and any attached devices.
Figure 10. Location of the Standby Power LED
2.16
Debug Interfaces
The following debug support is provided on the Intel Embedded Board N2800:
XDP (Extended Debug Port) connector supporting 3.3V JTAG is provided at J20 (on the
reverse side of the board) for processor run control debug support.
The 10-pin serial ports provide UART connectivity (see Section 2.8.1)