Intel 480T, Руководство пользователя

Страница: 269 / 367

C H A P T E R 1 4 Access Policies
267
Routing Access Policies for DVMRP
The access policy capabilities for DVMRP are very similar to those
for RIP. If the DVMRP protocol is used for routing IP multicast
traffic, the switch can be configured to use an access profile to
determine any of the following:
• Trusted Neighbor — Use an access profile to determine trusted
DVMRP router neighbors for the VLAN on the switch running
DVMRP. To configure a trusted neighbor policy, use the following
command:
config dvmrp vlan [<name> | all] trusted-
gateway [<access_profile> | none]
• Import Filter — Use an access profile to determine which
DVMRP routes are accepted as valid routes. To configure an
import filter policy, use the following command:
config dvmrp vlan [<name> | all] import-filter
[<access_profile> | none]
• Export-Filter — Use an access profile to determine which
DVMRP routes are advertised into a particular VLAN, using the
following command:
config dvmrp vlan [<name> | all] export-filter
[<access_profile> | none]
Example
In this example, the network used in the previous RIP example is
configured to run DVMRP. The network administrator wants to
disallow Internet access for multicast traffic to users on the VLAN
Engsvrs . This is accomplished by preventing the learning of routes
that originate from the switch labeled Internet by way of DVMRP
on the switch labeled Engsvrs.
To configure the switch labeled Engsvrs, use the following
commands:
create access-profile nointernet ipaddress
config access-profile nointernet mode deny
config access-profile nointernet add 10.0.0.10/32
config dvmrp vlan backbone trusted-gateway
nointernet