INTEGRAL LED DMX512 DECODER ILCTDMX001
WARNING
DO NOT CONNECT THE DMX512 DECODER DIRECTLY TO A MAINS SUPPLY
THE DMX512 DECODER MUST ONLY BE CONNECTED TO A SUITABLE DC12V-36V LED DRIVER
SWITCH OFF POWER AT THE MAINS BEFORE INSTALLING THE PRODUCT
PLEASE READ BEFORE USE
IP20
IMPORTANT NOTICE
1. INTRODUCTION
2. PARAMETER
• Switch OFF power at the mains before installing the product.
• This product should be installed according to the instructions in this guide and by a qualified electrical installer.
• All electrical work must be completed in accordance with the latest IET wiring regulations (formally IEE) for
the UK or in accordance with all applicable regulations and laws in the country in which it is being installed.
• Always disconnect or switch off the power supply before making any adjustment to the wiring.
• Observe the operating temperature of the product: Max Tc 75°C.
• Limited 5 Year Warranty. This DMX512 Decoder is for indoor use only. Improper installation, abuse or miss-
powering of the decoder or failure to use the decoder for its intended use will void the warranty. Proof of
purchase is required for all returns. Your statutory rights remain unaffected.
Please see www.integral-LED.com/warranty.
Questions? Please contact you supplier or see www.integral-LED.com
The Integral ILCTDMX001 DMX512 Decoder is designed as standard DMX512 compliant control interface,
receiving DMX512 signal and distributing to LED strip products with constant voltage (DC 12V-36V). You
will be able to set up the DMX address as your preference and the address is shown on the 3-digit display.
ILCTDMX001 DMX512 Decoder is compatible with a standard DMX512 master controller.
• Input Voltage: DC12V–DC36V, Constant Voltage
• Output Current: Max 32A, 8Ax4CH
• Output Power: Max 384W (12V) / 768W (24V) /
1152W (36V)
• IP Rating: IP20
• Ambient Temperature: Ta -20°C to +50°C.
• Operating Temperature: Max Tc 75°C.
• Dimensions: L170×W59×H29 (mm)
• Weight (N.W.): 215g
