1
Using the RC-550M Remote Controller
You can use the RC-550M remote controller to control
your other AV components, including those made by
other manufacturers. To do this you can:
• Enter a remote control code for the component that
you want to control (e.g., DVD, TV, VCR).
• Learn commands directly from the other component’s
remote controller (see page 6).
• Use the Macro function to learn a sequence of actions
(see page 7).
• You can also edit the remote controller modes (see
page 9).
By entering the appropriate remote control code for each
of your components, you can control each component by
selecting the relevant remote controller mode: DVD, TV,
VCR, CBL (cable), or SAT (satellite).
Remote Control Codes for an Integra/
Onkyo DVD Player
The remote control code that you use with an Integra/
Onkyo DVD player depends on whether it’s connected
via
, as follows:
5001:
Use this code if you’ve connected an
cable
and an RCA/phono analog audio cable to your
DVD player. This is the default setting, so if
you’re using
, you don’t need to change it.
Point the remote controller at the DTR-8.4 to
operate the DVD player.
5002:
Use this code if your DVD player doesn’t have
an
socket, or you’re not using
. Point
the remote controller at the DVD player to
operate it.
Entering a Remote Control Code
1
Look up the appropriate remote
control code for the component.
See “Remote Control Codes” on
page 2
2
Press and hold down the [Cus-
tom] button for more than three
seconds.
The remote controller enters Custom
mode.
3
Roll the scroll wheel to select
“PRGRM,” and then press the
scroll wheel.
4
Roll the scroll wheel to select the
the remote controller mode you
want to use with the component,
and then press the scroll wheel.
The following remote controller modes
can be selected: DVD, TV, VCR, CBL,
or SAT.
5
Use the number buttons to enter
the 4-digit remote control code.
If the code is accepted,
the following
appears on the display for awhile, and
then the normal display reappears.
If the code is not accepted,
after the
message “RETRY” has been displayed,
the code entry display reappears, and
you should try entering the code again.
To cancel this procedure at any point,
press the [Custom] button.
6
Select the remote controller
mode, point the remote control-
ler at the component, and check
its operation.
RC-550M Owners Manual September 30 2005 3:00 PM