Integra DTR-70.2, Инструкция по эксплуатации

Страница: 108 / 124

108
En
■
Stand-by power consumption
■
The sound changes when I connect my
headphones
■
The speaker distance cannot be set as required
■
How do I change the language of a multiplex
source
■
The u functions don’t work
■
The functions System On/Auto Power On and
Direct Change don’t work for components
connected via
u
■
When performing “Audyssey MultEQ ® XT32
Room Correction and Speaker Setup”, the
measurement fails showing the message
“Ambient noise is too high.”.
■
The following settings can be made for the
S-Video and composite video inputs
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
source that you want to set, press Setup .
2. Use
e
/
r
to change the setting.
3. Press the input selector button for the input source that you
want to set when you’ve finished.
• Video Attenuation
This setting can be made for the BD/DVD , VCR/DVR ,
CBL/SAT , Game , or AUX input.
If you have a games console connected to the composite
video input, and the picture isn’t very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain reduced by 2dB.
Others
In the following cases, the power consumption may
reach up to a maximum of 30W (
DTR-80.2 )/
90W ( DTR-70.2 ):
1. You are using the Universal Port jack.
2. “ Control ” is set to “ Enable ” in the “ Network ”
setting.
3. “ HDMI Control(RIHD) ” setting is set to
“ On ”. (Depending on the TV status, the AV
receiver will enter Standby mode as usual.)
68
,
79
,
93
When a pair of headphones is connected, the listen-
ing mode is set to Stereo, unless it’s already set to
Stereo, Mono or Direct. —
In some cases, corrected values suitable for home
theater use may be set automatically. —
Use the “ Multiplex ” setting on the “ Audio Adjust ”
menu to select “ Main ” or “ Sub ”.
57
To use
u
, you must make an
u
connection and an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
20
While Zone 2, Zone 3 or Zone 4 is selected, the
u
functions don’t work.
—
These functions don’t work when Zone 2/3/4 is
turned on. —
This can be caused by any malfunction in your
speaker unit. Check if the unit produces normal
sounds. —
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit’s malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.