Integra DTR-40.2, Инструкция по эксплуатации

Страница: 88 / 104

88
En
You’ll need to enter a code for each component that you
want to control.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Integra/Onkyo components that are connected via
u
are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that’s not connected
via
u
, use the following remote control codes:
•
BD/DVD

30627 :
Integra/Onkyo DVD player without
u
• TV/CD

71817 :
Integra/Onkyo CD player without
u

11807 :
TV with
p
8
If you can control component, press Receiver ,
use q / w to select “Works”, and then press
Enter .
The “Remote Mode Setup” menu appears.
If you cannot control component, press
Receiver , use
q
/
w
to select “Doesn’t work(Try
next code)” and press Enter .
The next code appears.
9
Press Setup .
The setup menu closes.
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down Remote Mode to which you
want to enter a code, press and hold down Dis-
play (about 3 seconds).
The Remote Mode button lights.
Note
• Remote control codes cannot be entered for Receiver
and Zone2 .
• Only TV remote control codes can be entered for TV .
• Except for Receiver , TV and Zone2 , remote control
codes from any category can be entered as Remote
Mode . However, these buttons also work as input selector
buttons (
➔
25 ), so choose a Remote Mode that corre-
sponds with the input to which you connect your compo-
nent. For example, if you connect your CD player to the
CD input, choose
TV/CD when entering its remote control
code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
Remote Mode
button flashes twice.
If the remote control code is not entered success-
fully,
Remote Mode button will flash once slowly.
Remote Control Codes for Integra/
Onkyo Components Connected via
u
1
Make sure the Integra/Onkyo component is con-
nected with an
u
cable and an analog audio
cable (RCA).
See “Connecting Integra/Onkyo u Components”
for details (
➔
20 ).
2
Enter the appropriate remote control code for
Remote Mode
.
•
BD/DVD

31612 :
Integra/Onkyo DVD player with
u
• TV/CD

71327 :
Integra/Onkyo CD player with u

42157 :
Onkyo cassette tape deck with
u
•
Port

81993 :
Onkyo Dock with
u
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via
u
, press
and hold TV/CD to switch to TAPE.
3
Press Remote Mode , point the remote controller
at the AV receiver, and operate the component.