Integra DTR-40.2, Инструкция по эксплуатации

Страница: 73 / 104

73
En
Note
• This procedure can also be performed on the AV receiver by
using its
Setup
, arrows, and
Enter
.
■
Mac Address
This is the AV receiver’s MAC (Media Access Control)
address. This address cannot be changed.
■
DHCP
This setting determines whether or not the AV receiver
uses DHCP to automatically configure its IP Address,
Subnet Mask, Gateway, and DNS Server settings.

Enable :
DHCP enabled.

Disable :
DHCP disabled.
If you select “ Disable ”, you must configure the “ IP
Address ”, “ Subnet Mask ”, “ Gateway ”, and “ DNS
Server ” settings yourself.
■
IP Address
If you set the “ DHCP ” setting to “ Disable ”, you must
specify an IP address. Enter a static IP address provided
by your ISP.
The IP address must be within the following ranges.

Class A:
10.0.0.0 to 10.255.255.255

Class B:
172.16.0.0 to 172.31.255.255

Class C:
192.168.0.0 to 192.168.255.255
Most routers use Class C IP addresses.
■
Subnet Mask
If you set the “ DHCP ” setting to “ Disable ”, you must
specify a subnet mask address.
Enter the subnet mask address provided by your ISP (typi-
cally: 255.255.255.0).
■
Gateway
If you set the “ DHCP ” setting to “ Disable ”, you must
specify a gateway address.
Enter the gateway address provided by your ISP.
■
DNS Server
If you set the “ DHCP ” setting to “ Disable ”, you must
specify a DNS server.
Enter the DNS server addresses provided by your ISP.
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
■
Control
This setting enables or disables control over the network.

Enable:
Control over the network enabled.

Disable:
Control over the network disabled.
Note
• When set to “ Enable ”, power consumption on standby mode
increases.
■
Port Number
This is the network port used for control over the network.
Note
• Set the port number between from “49152” to “65535”.
5
When you’ve finished, press Return .
The save confirmation screen appears.
6
Use
q
/
w
to select “Save”, and then press Enter .
When modifying network settings, after modifying it
is necessary to execute “
Save ”.
7
When you’ve finished, press Setup .
The setup menu closes.
Save
Cancel
7-6. Network