133
≫
≫
≫
≫
≫
≫
•
To perform the Initial Setup again after the setting is completed, press ,
select "8. Miscellaneous" - "Initial Setup", and press Enter.
1. Speaker Setup
Select the connected speaker configuration.
Note that the image on the screen changes each time you select the number of
channels in "Speaker Channels".
Speaker Setup
Speaker Channels
Subwoofer
Height Speaker
Zone Speaker
Bi-Amp
Speaker Impedance
Select how many speakers you have.
Next
7.1 ch < >
Yes
---
No
No
6ohms or above
2. AccuEQ Room Calibration
Place the supplied speaker setup microphone at the listening position. The unit
automatically measures the test tones output from each speaker, and sets the
optimum volume level for each speaker, the crossover frequencies, and the
distance from the listening position. This also automatically adjusts the equalizers
for the speakers, and enables correction of sound distortion caused by the
acoustic environment of the room.
•
It takes between 3 and 12 minutes for calibration to be completed. Each
speaker outputs the test tone at high volume during measurement, so be
careful of your surroundings. Also, keep the room as quiet as possible during
measurement.
•
If you connect a subwoofer, check the power and volume of the subwoofer.
Set the subwoofer volume to more than half.
•
If the power of this unit suddenly turns off, the wires in the speaker cables
have touched the rear panel or other wires, and the protection circuit is
working. Twist the wires again securely, and make sure they do not stick out of
the speaker terminals when connecting.
1.
Place the supplied speaker setup microphone at the listening position, and
connect it to the Setup Mic jack on the main unit.
Setup Mic
When placing the speaker setup microphone on a tripod, refer to the
illustration.
2.
Confirm a test tone is output from the subwoofer and press Enter.
3.
Press Enter. Then, test tones are output from each speaker, and the
connected speakers and the noise in the surrounding environment are
automatically measured.
4.
The measurement results in step 3 are displayed. Select "Next", and press
Enter. The test tones are output again. Then, the unit automatically sets the
optimum volume level, crossover frequency, etc.
5.
When the measurement is completed, the measurement results are displayed.
You can check each setting using the cursors / . Select "Save" and press
Enter to save the settings.
6.
Disconnect the speaker setup microphone.
3. Multi Zone Sound Check
Output test tones to ZONE 2 to enjoy audio in a separate room (ZONE 2) in
addition to the main room.
4. Network Connection
Make the network connection settings. There are two methods for network
connection.
"Wired"
: Use a wired LAN to connect to a network.
"Wireless"
: Wi-Fi connection using an access point such as a wireless LAN
router. There are two methods for Wi-Fi connection.
