Functions
i-modul ISDN HIX V4
6.5
Connection Configuration of the i-modul ISDN HIX V4
at the ISDN Basic Access
6.5.1
Configuration at Multipoint Interface (PMP, Point-to-Multipoint)
In order to operate the i-modul ISDN HIX V4 at a multipoint interface, you must
configure it accordingly and configure an own phone number (MSN). The MSN is
always configured without area code. When operating at a PABX, you must only
enter the extension number.
The operation at a multipoint interface is configured and "*" is entered as phone
number in the default setting.
Configuration with AT commands
To configure the multipoint interface
connection type use the command
AT**PTP=0
To set the phone number (MSN) use the
command
AT#z=<N>
To save the settings use the command
AT&W
6.5.2
Configuration at Point-to-Point Interface (PTP, Point-to-Point)
You can operate the i-modul ISDN HIX V4 at a point-to-point interface. A point-to-
point interface is a special ISDN access, which allows that devices behind the
access are accessible from outside with dedicated extension numbers.
In order to operate the i-modul ISDN HIX V4 at a point-to-point interface, you must
configure the "Point to point" type of connection.
This is not valid for the operation at an ISDN PABX. For this, proceed
as described under Configuration at Multipoint Interface (PMP, Point-
to-Multipoint).
Configuration with AT commands
To configure the point-to-point interface
connection type use the command
AT**PTP=1
To set the phone number (MSN) use the
command
AT#z=<N>
To configure the TEI (is assigned by the
phone provider) use the command
AT**TEI=<N>
To save the settings use the command
AT&W
30