i-modul ISDN HIX V4
Functions
6.4
Remote Configuration
You can configure the i-modul ISDN HIX V4 with another ISDN TA from remote.
You can configure a password, authorised callers as well as a remote configuration
number to restrict access. The configuration is performed via the TA+Configurator.
This is automatically started after the connection establishment for remote
configuration.
The remote configuration is active as default. No password is entered and all callers
are authorised.
6.4.1
Remotely Configuring the i-modul ISDN HIX V4
The following describes the commands for the remote configuration of an i-
modul ISDN HIX V4 using a second i-modul ISDN HIX V4:
Your terminal program is connected to the local i-modul ISDN HIX V4.
1.
Configure the B channel protocol X.75 at the local i-modul ISDN HIX
V4 using the command
ATB10.
2.
Establish an ISDN connection to the "Remote TA" using the AT
dialling command. Use the command
ATD<phonenumber>e.
The extension "e" at the end of the phone number establishes an
internal control connection to the remote TA
The "Remote TA" replies with a password request.
password:
3.
Enter the correct password.
If the i-modul ISDN HIX V4 has been reset to factory settings: enter no
password, just press Enter.
Each line starts with a "#" character during remote configuration.
the TA+Config
Use
urator commands (refer to table TA+Configurator
commands).
o read out the settings for example, use the command
dul ISDN HIX V4, which is to be remotely
configured, now.
5.
Save the settings (if desired) with the command
6.
Exit the remote configuration with the command
In order t
showall
.
4.
Configure the i-mo
save.
go
.
27