Functions
INSYS GSM 4.3
12.26
Manual Sending of Messages
The collective message or the individual pulse messages can be sent manually.
Configuration with HSComm
A manually triggered dispatch of the messages with the HSComm soft-
ware is not possible.
Configuration with AT commands
In order to send the commands, use the
command
Replace
<input>
with the number of the
input, for which the SMS is to be sent.
Replace
<pulse_no>
with the pulse num-
ber, for which the SMS is to be sent
(1…10). If a single alarm is configured, 1
must be entered here.
AT**SMS=<input>,<pulse
_no>
If the messages 1 to 10 are triggered, the sent message will always con-
sist of the collective message and the attached pulse message. The mes-
sage will be sent to the configured recipient number as well as all possi-
bly configured additional recipients.
12.27
Operation with a PLC
The INSYS GSM 4.3 can be operated at a programmable logic controller. Settings
recommended by INSYS for a INSYS GSM 4.3, which is used at the PC to commu-
nicate with the PLCs, are available for certain controllers. The respective configura-
tion files can be found under http://www.insys-tec.de/en/en/plc/ or in the “Configu-
ration for PLC” section of the CD delivered with the unit.
Configuration with HSComm
You may load setting files into HSComm under the menu item “PLC”.
Moreover, you can store settings for the PLC to a file. You can send
these settings to the INSYS GSM 4.3 then.
Configuration with AT commands
You can also perform these settings with
AT commands. The settings depend on you
PLC and cannot be given here generally
therefore.
80