4
Installation
1. Confirm that the Eurorack synthesizer system is powered off.
2. Locate 14 HP of space in your Eurorack synthesizer case. Locate an
additional, but optional 4 HP of space in your Eurorack synthesizer
case for the included expander.
3. Connect the 6 pin side of both IDC expansion cables to both of the
2x3 pin headers on the back of the main module, confirming that
the red stripes on the expansion cables line up with the indicators on
the main module.
4. Connect the 6 pin side of both IDC expansion cables to both of the
2x3 pin headers on the back of the expansion module, confirming
that the red stripes on the expansion cables line up with the
indicators on the expansion module.
5. Connect the 10 pin side of the IDC power cable to the 2x5 pin
header on the back of the module, confirming that the red stripe on
the power cable is connected to -12V.
6. Connect the 16 pin side of the IDC power cable to the 2x8 pin
header on your Eurorack power supply, confirming that the red
stripe on the power cable is connected to -12V.
7. Mount the Instruō
cruïnn
in your Eurorack synthesizer case.
8. Power your Eurorack synthesizer system on.
Note:
This module has reverse polarity protection.
Inverted installation of the power cable will not damage the module.
Specifications
• Width: 14 HP + 4 HP Waveform and CV Expansion Module
• Depth: 27mm
• +12V: 180mA
• -12V: 180mA
