Instron 1000KPX-J3, Руководство по концепции системы

Страница: 40 / 58

Chapter 3: Additional System Details
40 M47-17036-EN
SERVICE Display: Provides an indication of self-tests that are performed by the controls during system startup. You
should see the following general sequence: the two 7-segment LEDs count up to “21” and then
back down, and then the letter “P” will flash alternately with the number “22”. This entire
sequence typically takes between one and two minutes to complete. “P” indicates the all self-
tests have passed. If the LEDs should flash the letter “F” at any time during the sequence, this
indicates that a self-test has failed. If this occurs, you should contact your local Instron Services
department as directed on page
14 for assistance in troubleshooting the failure.
When conditions are normal, the
T
indicator is green and the
A
indicator is blinking red.
HPS, A: A female 14-pin interface that connects the HPS to the control unit.
Position, H: A female 9-pin interface that connects the system’s position encoder to the control unit.
User Control Panel, N: An interface that connects the user control panel to the control unit.
HPS Controls, M: A female 15-pin interface that connects the HPS control box to the control unit.
Frame, R: A female 10-pin interface that connects various frame functions to the control unit.
Ground: A ground lug that connects the control unit to an earth ground. Typically connects to a ground lug
on the frame base.
Power Entry Module: Provides a male 3-prong connection for incoming power and a power ON/OFF switch.
Table 6. 59 Series control unit function descriptions. (Continued)
Figure 18. The 59 Series control unit.
Front Panel
Rear Panel
Expansion Port
(optional)