Page 6 of 13
2634-222 - Rev: 2/11/2019 9:16 AM
INSTEON Setup
Some products have subtle differences in their setup procedures. Please refer to the other devices’ owner’s
manuals for details.
INSTEON Controllers, Responders and Links
Let’s define a few terms.
The INSTEON “transmitter” is called a
controller
The INSTEON “receiver” is called a
responder
The association between the controller and responder is called a
link
Note that a link is one way. If you wish to have control “the other way,” simply add a link “the other way.”
Make On/Off Outdoor Module a Responder
1) Press and hold controller set button until it beeps
Controller LED will start blinking
You will have four minutes to complete the next steps before linking mode times out
2) Use On/Off Module set button to adjust load to desired state (on or off)
3) Press and hold On/Off Outdoor Module set button until it double-beeps
Controller will double-beep and its LED will stop blinking
4) Test link by tapping controller button on and off
Lamp connected to On/Off Outdoor Module will respond appropriately
Note:
-
The link just created is one way. See
Make On/Off Outdoor Module a Controller
to add another
link to keep the two products in sync.
-
If you wish the load to be off when link is activated—such as for an “all off” scene—turn off the load in step
#2.
Make On/Off Outdoor Module a Controller
1) Press and hold On/Off Module set button until it beeps
On/Off Module LED will start blinking green
2) Adjust responder to desired brightness state (such as on, 50% or even off)
3) Press and hold responder set button until it double-beeps
On/Off Module LED will stop blinking
4) Test by tapping On/Off Module set button to turn on/off
Responder will respond appropriately
Controller
Responder
Link
