23
4
Getting Started
4.1
Installing Server into the Rack
For detailed information on installing the server into the rack with rails supplied by
Inspur, see Rack Server Installation Guide.
If you would like to use non-Inspur rails, please contact Inspur Customer Service
first to ensure the server can be installed to the rack safely and properly. The
load-bearing capacity of non-Inspur rails must be higher than 50 kg (110.23 lb).
If not, you MUST use Inspur-supplied rails as using these non-Inspur rails may
cause such risks as installation failure. Inspur will not assume any responsibility
or liability for any damage or injury caused by this.
To reduce the risk of personal injury or damage to the equipment, DO secure the
mounting ears to the posts firmly to prevent the server from moving or sliding
out from the cabinet.
4.2
Power On/Off
To power on and off the server, press the power button.
To completely shut down the server, press the power button and disconnect the
power cables from the server.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power plug to disconnect power from the server. Pressing the power
button on the front panel does not shut off the system power completely. Some
power supplies and internal circuitry remain active until AC power is removed.
