Inspire M5, Руководство по сборке и эксплуатации

Страница: 22 / 32

STEP 15
A) Insert the Seat Stem Assembly (7) into the Seat Base Frame (4) as shown. Pull the pop pin out to
allow the seat to lower to a normal height. Then attach the Seat Base Assembly (35) to the Seat
Stem Assembly using the two M10*50 bolts (96) and two M10 Washers (86). Tighten these bolts
now but do not over tighten them or damage can occur. Now install the Orthopedic Pad (30) on
the Seat Base by working the edge of the pad into the groove of the Seat Base on all sides. Do not
use sharp objects during installation. Finally slide the Thigh Pads (37) onto the Seat Stem as
shown and secure with Velcro.
B) Install the Large Covered Foam Rollers (39) with the plastic inserts in them onto the lower arms of
the Leg Extension Assembly (15) as shown. Ensure that the Tube inserts are facing inwards.
Secure the Rollers with the Aluminum Endcaps (50) and the M10* Flat Head Screws (83). Tighten
the screws at this time with the 6# Allen Wrench supplied. Next install the other Large Covered
Foam Rollers (38) on to the upper arms of the Leg Extension Assembly by first sliding on the
plastic Spacer Tubes (49), large plastic Washers (69) and Rollers (38) on to the arms and secure
with the Aluminum End Caps (50) and M10 Flat Head Screws (83). Tighten the screws at this time
with the 6#Allen Wrench.
PAGE 19