www.insigniaproducts.com
37
4.8 Cu. Ft. Electric Convection Range with Steam Cleaning
Cleaning the oven racks
1
Pull a rack straight out until it stops.
2
Lift the front of the oven rack and pull to remove it from the oven.
3
Clean by hand in hot, soapy water with a plastic or soap-filled scouring pad or sponge, then dry with a soft cloth. Do
not use steel wool,
4
To replace the rack, place the back edge of the rack on the a rack support, then lift the front of the rack and slide it into
the oven. If a rack becomes difficult to slide, rub the side rails with wax paper or a cloth containing a small amount of
cooking oil. This helps the rack slide more easily in the tracks.
Cleaning the oven door
The oven door has multiple surfaces that require different cleaning techniques. The gasket on the oven door frame should
never be cleaned or moved to clean other surfaces. The gasket is made of woven material which is essential for a good
heat seal.
1
Clean the inside door surface by hand with hot, soapy water and a soapy plastic scouring pad. Do not let moisture get
inside the door assembly.
2
Rinse and dry thoroughly with a clean, soft cloth.
3
Clean the outside door stainless steel surfaces by following the instructions in Cleaning stainless steel surfaces on
page 36.
4
Clean the glass window with glass cleaner or warm, soapy water with a thorough rinse. Do not let moisture get inside
the door assembly.
Cleaning the surface element control knobs
1
Make sure that all surface element knobs are in the OFF position.
2
Pull the control knobs straight off the surface element control valve stems. Do not clean the control knobs in a
dishwasher. They are not dishwasher-safe.
3
Clean the knobs in warm, soapy water. Rinse and completely dry all surfaces (including back and stem hole).
4
Clean stainless steel surfaces with a stainless steel cleaner on a damp, soft cloth.
5
Replace the control knobs in the OFF position by pushing them straight onto the control valve stems.
CAUTION:
Make sure that the oven racks have cooled before removing them.
CAUTION:
• DO NOT clean the oven door gasket. The oven door gasket is made of a woven material which is essential for a good seal. Care
should be taken not to rub, damage, or remove this gasket.
• DO NOT immerse the door in water.
• DO NOT spray or let water or the glass cleaner to enter the door vents.
• DO NOT use oven cleaners, cleaning powders, or any harsh abrasive cleaning materials on the outside of the oven door.
WARNING:
• Do not use spray cleaners on the surface element control panel. Spray entering the valve holes could contact electrical components
resulting in death, personal injury, or product damage.
• The knobs and the valve stems must be completely dry before you reinstall them.
Door gasket–Do not
clean.
Oven door
