www.insigniaproducts.com
9
NS-PMM6230
STEP 2-Option 2: Attaching your mount through a desktop grommet hole
If you want to install your mount on a desktop edge, see STEP 2-Option 1: Attaching your monitor mount to a desktop
edge on page 7.
The desk should between 1 in. (2.5 cm) and 2.8 in. (7 cm) thick and strong enough to bear the weight of your monitors.
1
Select one of the existing cable passage holes in your desktop and remove any decorative grommet or lid.
2
Use the 4 × 4 Allen wrench (
I
) to remove the four screws on the base support plate (
11
), then remove the bottom plate.
3
Insert the tube bottom cover (
10
) in the base support plate, then insert the support tube (
9
) into the tube bottom
cover. Make sure that the holes on the bottom cover and the plate are aligned. Secure the assembly using the
M4 × 16 mm screw (
E
).
Notes:
• Make sure that the grommet hole is between .5 and 2 inches (1.2 and 5.0 cm).
• Make sure that the tabletop or desktop thickness is between 1 and 2.8 inches (2.5 and 7 cm).