www.insigniaproducts.com
19
NS-HF2003
Anti-tip safety strap installation instructions
You’ll need
1
Use a drill with a 5/16" (8 mm) drill bit to drill two holes in your wall approximately two inches below the position of the
mounting tabs on your stand, then insert the plastic sockets (
WB
) into the holes.
2
Secure the mounting tabs (
WC
) to the plastic sockets with two of the wood screw 4 × 25 × 8 mm (
WA
).
3
Thread the plastic mounting straps (
WD
) through the tabs on your stand and on the wall, then thread the straps
through the strap holes.
4
Pull the straps to tighten them, then thread the straps back through the strap holes to lock them in place.
Note:
We recommend that you install the anti-tip strap as a safety precaution.
Notes:
• You attached the mounting tabs to your stand in STEP 6 - Attach the back panel. on page 13.
• You can use a rubber mallet to lightly tap the sockets into the holes.
WA
Wood screw
4 × 25 × 8 mm (2)
WB
Plastic socket
(2)
WC
Mounting
tab (2)
WD
Plastic mounting
strap (2)
Phillips screwdriver
Rubber mallet
