18
www.insigniaproducts.com
STEP 7: Installing the cabinet top
You need:
1
Insert two large KD cams (
E
) into the upper back brace (
6
). Make sure that the cam lock arrows are pointing toward
their corresponding cam-lock screw holes.
2
Place the cabinet top (
1
) on top of the assembly, align the KD bolts and dowels with the holes in the corresponding
pieces, then push the pieces together. Make sure that the edges of the panels are flush with each other, then
tighten the KD cams.
3
Use a Phillips screwdriver to attach the top panel (
1
) to the right and left side panels (
2
and
3
) with six 4 x 22 screws
(
V
) through the holes in the connection bars (
18
).
4
Use a carpenter’s square to make sure that the cabinet is square.
5
Use a Phillips screwdriver to install six plastic triangle block supports (
T
) into the cabinet sides at equal intervals
around the back of the cabinet, using the 3 x 16 mm screws (
S
).
E
KD Cam (large) (2)
Phillips screwdriver
S
3 x 16 screws (6)
T
Plastic triangle block
support (6)
V
4 x 22 screw (6)
°
90