8 of 14
An Alliance Technology Company
600 Dekora Woods Blvd. Saukville, WI 53080
Toll Free: 800-488-8177 Local: 262-268-9330 Fax: 262-268-9952
An Alliance Technology Company
If the unit does not turn on, please verify that the internal battery has been charged or
connect the unit to a 13.8-15VDC or 110/220VAC power source.
If the unit does not turn on after charging the unit or connecting the unit to a 13.8-
15VDC or 110/220VAC power source, please contact an Authorized InsightVision
Service Center.
Verify that the Xpress Command Module is receiving adequate power by verifying
the YELLOW LED is not illuminated or flashing. If the YELLOW LED lights up at
any time, the system is indicating a low power condition of either the built-in internal
batteries or an external power source (i.e. low battery on a vehicle).
YELLOW LED is illuminated or flashing
without an external power source
connected
.
A flashing YELLOW LED indicates the internal battery is low and will need to be
plugged in or recharged within ½ hour.
As soon as it is convenient, connect the unit to a 13.8-15VDC or 110/220VAC power
source. When connected to an external supply, the batteries will recharge and the
GREEN LED will flash indicating the batteries are charging. BATTERIES ARE
FULLY CHARGED WHEN GREEN LED IS ILLUMINATED AND NO LONGER
FLASHING.
An illuminated YELLOW LED indicates the internal battery is extremely low and
will shut down within 30 seconds.
Immediately connect the unit to a 13.8-15VDC or 110/220VAC power source. When
connected to an external supply, the batteries will recharge and the GREEN LED will
flash indicating the batteries are charging. BATTERIES ARE FULLY CHARGED
WHEN GREEN LED IS ILLUMINATED AND NO LONGER FLASHING
YELLOW LED is illuminated or flashing
with an external power source connected
.
A flashing YELLOW LED indicates the external power source is low. The advanced
Xpress Command Module may continue operating indefinitely in this state as long as
the power level does not decrease further.
An illuminated YELLOW LED indicates the external power source is low and the
Xpress Command Module will shut down within 30 seconds.
