Page | 6
Product Description
LPS1800 Outdoor Industrial PoE Switch features with four PoE Ethernet ports and comply to
10/100Mbps, IEEE802.3at/af PoE and two Gigabit SFP fiber optics interfaces. The power supply of single
PoE port can be up to 15.4W for 802.3af and 25.5W for 802.3at. The transfer data can be up to 120Km
from SFP fiber port to a control center. Additionally, the product also features with an anti-
electromagnetic interference that is designed for harsh outdoor applications and the 3KV network port
surge protection can adapt to harsh outdoor environment and ensure the reliability of the uninterrupted
PoE operations. The outdoor enclosure is rated at IP68, and the system is able to operate under -
40 ~ +75 ˚
C temperature range.
Product Features
1.
Comply to IEEE 802.3, IEEE 802.3u, IEEE 802.3z, IEEE 802.3ab, IEEE 802.3x, IEEE 802.1D, IEEE
802.3at, IEEE 802.3af, IEEE 802.1Q IEEE 802.1p, IEEE 802.1x, IEEE 802.1W, SNMP, IGMP
standards
2.
10/ 100M self-sensing RJ45 port, support PoE power supply function; All ports support auto-flip
(Auto MDI/MDIX);
3.
Each PoE port can provide power up to 15.4W p er IEEE 802.3af standard; Supply power for
powered devices compatible with IEEE802.3af;
4.
Each PoE port can provide power up to 25.5W p er IEEE 802.3at standard; Supply power for
powered devices compatible with IEEE802.3at;
5.
Support IEEE802.3x full duplex flow control and duplex backpressure flow control;
6.
8.8G backplane bandwidth;
7.
1K MAC address table;
8.
Its 3KV network port surge protection can adapt to harsh outdoor environment; Under the
temperature of -40 ~ +75
˚
C, working at a full load 150W for 802.3af and 225W for 802.3at;
9.
The 2 gigabit SFP fiber ports are capable of high bandwidth and for up to 120KM long distance
transmission.
Installation
a.
Before installation, please ensure the following:
b.
All PD devices, i.e., PoE Clients, meet the power requirement of the connecting devices.
c.
All PD devices, i.e., PoE Clients, match with the power receiving device power pinout
specification (1/2+ & 3/6-)
d.
Connect the power cable to a power source, 110 ~ 240V AC, then the switch will automatically
initialize, and LED lights status will display as following:
e.
Except the POE port lights, all the other lights will go through the process of “on
-off-on-
off”,
which means the installation is successful.
f.
Sys (Power) LED remains ON
g.
Connect the network devices with network cables to the POE switch port though the waterproof
connectors, then secure the Top Cover with the four screws to the Bottom Case
h.
After the Ethernet and/or fiber optics network devices are connected, please refer the LED
Indicator Description Table Below on Page 6
