Installation
10
INOXPA S.A.U.
20.005.30.01EN · (0) 2019/02
5.4. LOCATION
Place the agitator in such a way as to facilitate inspections and checks. Leave enough room around the agitator
for service, disassembly and maintenance operations. It is very important to be able to access the electric
connection device of the agitator, even when in operation.
For a good agitation process, it may be necessary to place a deflector in the tank. Ask our Technical
Department for information on any particular application. If required, the approximate dimensions for the
deflector for different tank diameter are shown in the next figure and the next table:
5.5. ELECTRICAL INSTALLATION
Before connecting the electrical motor to the mains, check local regulations on electrical safety as well as the
applicable standards.
Check the instructions manual of the manufacturer of the motor for information on how to connect it to the
mains.
Take the connection of the electrical motors must be performed by qualified personnel.
Take the appropriate measures to prevent any fault.
The motor must be provided with devices for protection against power overload and short-circuits.
The agitator cannot be used in areas where there is a risk of fire or explosion when this has not
been specified in the order.
D
300
400
500
600
800
1000
1200
1600
2000
2500
3000
3500
4000
A
20
30
35
40
50
70
80
115
130
180
200
240
280
S
5
5
10
10
10
15
20
20
30
30
50
50
50
2
0
.0
0
5
.3
2
.0
0
0
3
