8/28/18 05606E © Inovonics, 2018 - www.inovonics.com
EN1224 Multiple Condition Pendant/
EN1224-ON Multiple Condition On/Off
Pendant
Installation Instructions
1 Overview
The EN1224 multiple-condition pendant can send up to ten
conditions; the EN1224-ON multiple condition on/off pendant has
the buttons configured for on/off applications.
1.1 Inovonics Contact Information
If you have any problems with this procedure, contact Inovonics
technical services:
• E-mail: [email protected].
• Phone: (800) 782-2709; (303) 939-9336.
1.2 EN1224/EN1224-ON Components
Figure 1
EN1224/EN1224-ON components
1.3 What’s in the Carton
• One multiple condition pendant or multiple condition on/off
pendant.
• One 3.0V lithium battery
2 Installation and Startup
2.1 Install/Replace the Battery
1.
Pry the housing apart at either end and pull the two halves
apart.
2.
If replacing a battery, remove the old battery.
3.
Install the new battery.
4.
Press the reset button to initialize the pendant.
2.2 Select the Frequency Band
EchoStream products are able to use a range of radio frequencies,
and must be configured for your geographic area. This product
ships with a default frequency range of 902-928 MHz for use in
North America. If you are using the product in North America, skip
to section 2.3, “Register the Pendant”; if you are using the product
in Australia or New Zealand, you will need to configure the pendant.
5.
Place a selection jumper on the appropriate frequency band
selection pins.
• Leave the jumper off the pins to set the frequency range to
902-928 MHz for North America.
• Place the jumper on the bottom two pins, marked NZ, to set
the frequency range to 921-928 MHz for New Zealand.
• Place the jumper on the top two pins, marked AU, to set the
frequency range to 915-928 MHz for Australia.
6.
Press the reset button to complete configuration.
Caution:
When pressing the reset button, make sure you don’t also
touch the frequency band selection pins. Touching the frequency
band selection pins while pressing the reset button can
inadvertently set the pendant to the wrong frequency band.
2.3 Register the Pendant
The pendant must be registered with the system in order to be
monitored and supervised. The pendant will send a check-in
message to the RF gateway every three minutes. Each pendant
has a unique factory-programmed identification number. Refer to
the control panel’s installation instructions for details on registering
a pendant.
1.
When prompted to reset the pendant, press and release the
reset button.
2.
Replace the cover.
3 Operation
Caution:
The EchoStream system should be tested regularly to
ensure operation. To test the system, activate each of the pendant’s
conditions and ensure an appropriate response.
3.1 Activating Conditions
The pendant can send up to ten conditions. The conditions will
depend on the application, as will the response. The application
controller must be designed to recognize simultaneous messages.
Condition signals are transmitted multiple times and are indicated
by the blinking transmission LED. Inovonics recommends you test
the pendant regularly.
For product and installation videos visit us at
www.inovonics.com/videos or use the QR
code below.
A
Reset button
B
Frequency band selection pins
C
Battery
B
A
C
Printing Instructions
1.
Print Duplex
2.
Align and orient back page to match front
page.
3.
Cut on dashed line
4.
Fold cutsheet in half along the 8.5" axis.
