Inovance SV660P Series, Руководство по оборудованию

Страница: 146 / 156

Appendix 1 Certifications and Standards Compliance
‑145‑
5.2.1 Requirement for Compliance with EMC Directive
The SV660P series servo drive, which is applicable to the first environment and
second environment, complies with EMC Directive 2014/30/EU and standard EN IEC
61800‑3.
As required by EMC Directive 2014/30/EU and standard EN IEC 61800‑3, install an EMC
filter on the input side of the drive and use shielded cables on the output side. Ensure
the filter is grounded properly and the shield of the output cable is grounded 360
degrees.
●
When applied in the first environment, the drive may generate radio interference.
In addition to the CE compliance requirements described in this chapter, take
additional measures to prevent radio interference if necessary.
●
The manufacturer of the system integrated with this drive is responsible for
ensuring compliance with EMC directives and EN IEC 61800‑3 based on the
application environment of the system.
Introduction to EMC standards
Electromagnetic compatibility (EMC) describes the ability of electrical and electronic
devices to work properly in the electromagnetic environment without introducing
electromagnetic interferences that disturb the operation of other local devices or
systems. In other words, EMC includes two aspects: 1) The electromagnetic
interference generated by a device during normal operation cannot exceed a certain
limit. 2) The device must have sufficient immunity to the electromagnetic interference
in the environment.
EN IEC 61800‑3 defines the following two types of environments.
●
First environment: Environment that includes domestic premises, and
establishments directly connected without intermediate transformers to a low‑
voltage power supply network which supplies buildings used for domestic
purposes
●
Second environment: Environment that includes all establishments other than
those directly connected to a low‑voltage power supply network which supplies
buildings used for domestic purposes
Drives are divided into the following four categories based on the intended
application environment.
●
Category C1 drive: Power drive system (PDS) with rated voltage less than 1000 V,
intended for use in the first environment