Copyright Innovative Technology Ltd 2008 GA820-1
1
2
16
15
4.3.5 PULSE
In Pulse mode the BV50 outputs a number of pulses on Vend 1. The number of pulses for
pulses
each channel is different and set to default values within the dataset. The number of
and duration can be modified using the Validator Manager software. Also a pulse multiplier
nd the pulse duration can be modified using a configuration card.
f 16 channels can be used in Pulse mode.
a
A maximum o
BV50 Connections:
Pin
Name
Type
Description
1
Vend 1
Output
Credit pulse stream output
2
Vend 2
Output
Not used
3
Vend 3
Output
Not used
4
Vend 4
Output
Not used
5
Inhibit
1
Input
Inhibit channe
W to
l 1 by h
n HIGH, hold LO
olding this pi
enable
6
Inhibit
2
Input
Inhibit channel 2 by ho
in HIGH, hold LOW to
lding this p
enable
7
Inhibit
3
Input
Inhibit channel 3 by ho
in HIGH, hold LOW to
lding this p
enable
8
In
it
hib
4
Input
Inhibit channel 4 by hol
pin HIGH, hold LOW to
ding this
enable
9
Busy
Output
Active LOW when the B
ansporting, reading or
V50 is tr
stacking a note
10
Escrow
Input
Enable the ESCROW
n by holding LOW
functio
11
-
-
Do not connect
12
-
-
Do not connect
13
Factory Use Only
Do not connect
14
Factory Use Only
Do not connect
15
+Vin
Power
Nominal 12V DC supply
16
0V
Ground
0V supply
Table 11
- Pulse Mode P
NO
:
• Channels higher than 4 cannot be individually
ally inhibited if
inhibits 1 to 4 are inhibited simultaneously.
• When using the 110V PSU
ace (SP4) must be used.
his operates the same as the standard pulse mode but the bill acceptor is always enabled
the state of the inhibit lines.
in Description
TES
inhibited, but will be glob
in-line module, the Special Pulse interf
T
whatever
•
Red Wire: 12V DC power supply (min.1.5 amp) DC only.
•
Black Wire: Ground Power Supply.
•
Green Wire: Credit pulse (active low) to board or coin switch.
BV50 Operations Manual 14
