Innovative Technology GA326-3, Руководство по эксплуатации

Страница: 11 / 38

NV9 Operations Manual GA326-4
11 of 38
© Copyright Innovative Technology Limited 2005
6: Interfaces: Hardware Description
The NV9 interface connector is located on the left side of the unit; it has 16 pins (see figure 3). Two are used
for the 0v and +12v power supply and there are five outputs and five inputs, the remaining four pins are
reserved for future use. An example mating connector is Molex type Part No: 39-51-2160
Figure 3 - Interface Connecter
6.1:Interface Connector Pin Details
The connector pin details are described below (see table 3); they use a 0.1" pitch header with 2 rows of 8
pins.
Pin Name Description
1 Vend 1 (binary bit
1)
Note accepted on Channel 1
Also the Pulse Stream output
Also the serial output pin in SSP Serial Mode
2 Vend 2 (binary bit
2)
Note accepted on Channel 2 pulse output.
3 Vend 3 (binary bit
4)
Note accepted on Channel 3 pulse output
4 Vend 4 (binary bit
8)
Note accepted on Channel 4 pulse output
5 Inhibit 1 Inhibit channel 1 by holding this pin HIGH. To Enable a channel the inhibit
must be held LOW. Also the Serial Input pin in RS232 serial mode
6 Inhibit 2 Inhibit channel 2 by holding this pin HIGH
7 Inhibit 3 Inhibit channel 3 by holding this pin HIGH
8 Inhibit 4 Inhibit channel 4 by holding this pin HIGH
9 Busy NV9 is validating and stacking output. Active low while the NV9 is reading,
transporting or stacking a note.
10 Escrow Operate Escrow function by holding LOW, refer to Escrow section in
parallel and binary modes and Escrow
Appendix B for full details)
11 Spare Spare
12 Spare Spare
13 Spare Spare
14 Spare Spare
15 +Vin Nominal 12V DC supply
16 0V 0v Supply
Table 3 - 16 Pin Connector Details
Interface Connector