Innova Srl
Page 22
N420220A_ManualeHRC_Rev07.EN
5.1.6
SYSTEM STATUS REQUEST
1
With the remote control active it is possible to
interrogate the system to understand the status and the
active functions.
Press the info button and wait for the remote control
to illuminate the status LEDs:
The remote control will show after a few seconds and
for a few seconds:
- Mode set
-Set speed
-Sensor and night functions if active
EXAMPLE:
In the next figure the remote control responded automatic
cycle and maximum speed.
System status request from remote control
5.1.7
AUTOMATIC OPERATION
1
By pressing the Auto key, the unit enters the
automatic mode.
In this mode, the fan unit detects the environmental
parameters (temperature, humidity and brightness) and
carries out the procedures and processing indicated below
to ensure the best environmental comfort.
Automatic mode operation
