© MASS ELECTRONICS Pty Ltd 2006
Models:
GENII CSFCAH REM:
Control Station with 3 Speed Fan
DS 15.10
August 2013
GENII CSFCAH REM
Control Station with 3 Speed Fan
Applications
Expands GENESIS Controller capabilities by providing a numeric output
display, numerical value input, a single toggle digital input switch and
three speed fan LED display output for distributed control via RS485.
Application Notes
A GENESIS Controller must have version 4 firmware installed to
support REM Modules. Version 5.0 or higher Config Software must be
used to configure a GENESIS Controller that has CSFCAH REM Modules
connected to it.
One GENESIS Controller can have up to 15 GENII CSFCAH REM Modules*
connected to it via the REM comms bus.
For detailed connection information to the pre-version 5 GENESIS
Digital Controller Family, please refer to DS 99.03
Overview
The Innotech GENII CSFCAH REM Control Station Module with
3 Speed Fan is an expansion device for the GENESIS range of
Digital Controllers.
The module is powered by 24VAC and provides a limited User
Interface to the GENESIS Controller. There are no physical
connections between field equipment and the GENII CSFCAH
REM, all input/output values are edited and viewed on the wall
unit.
The GENII CSFCAH REM may be located remotely from the
GENESIS Controller providing a distributed User Interface for the
system.
The GENII CSFCAH REM is configured via the wallplate and
programmed via the GEN2Config Software. The GENII CSFCAH
REM communicates with the Genesis Controller via the REM
Comms port. The remote link uses RS485 at a baud rate of
38400. For pre-version 5 controllers, a Gen II RMI Remote Module
Interface is required.
Please refer to DS 15.01 for further information.
Features
• One three decimal place numerical value input
• One three decimal place numerical output
• Two momentary digital inputs
• One LED digital display output
• Three ‘Fan Speed’ LED outputs
• Housed in a switchplate that mounts in standard electrical
wall plates
• RS485 interconnection between REM Modules
• 24VAC operation
• Wiring Diagrams for modules generated by GEN2Config
Software
• Adjustable user input range
• Configurable power on settings
• LED indication of network traffic on rear to ease debugging &
setup
Approvals
The GENII CSFCAH REM conforms to:
• EN 55011 Class B Group 1 & AS/NZS 2064:1997 for RCM
Labelling
• FCC Title 47 CFR, Part 15 Class A for FCC Marking
• UL listed to UL916, File Number E242628
