3-1
Basic Operation
3
Flat Panel Sensors Operation Manual 897N200608
Chapter 3
Basic Operation
3.1 Preparing the Flat Panel Sensor
This section describes how to prepare the flat panel sensor.
3.1.1 Type of Flat Panel Sensor
RIC 35G, RIC 43G, RIC 35C, RIC 43C, RIC 24C
The battery pack (optional) is required when the flat panel sensor is used in wireless communication
mode.
3.1.2 Number of the Connectable Flat Panel Sensors
To enable the flat panel sensor, its ID needs to be registered in advance by our official dealer or
INNOLUX Representative.
Up to a hundred flat panel sensors can be registered.
Up to five flat panel sensors can be connected.
3.1.3 Inserting/Removing the Flat Panel Sensor into/from the
Radiographic Examination Stand
Follow the procedure below to insert/remove the flat panel sensor into/from the radiographic
examination stand.
For details, see the Operation Manual for the radiographic examination stand
CAUTIONS
For the positioning at the time of inserting/removing the flat panel sensor, see the Operation
Manual for the radiographic examination stand.
CAUTIONS
Make sure that the flat panel sensor is installed in the radiographic examination stand securely.
CAUTIONS
Be careful not to have your fingers caught when inserting/removing the flat panel sensor into/
from the radiographic examination stand.
CAUTIONS
When pulling out/pushing in the tray of the radiographic examination stand after setting the flat
panel sensor on it, be careful not to drop the flat panel sensor or damage the tray.
