1-6
For Safe Operation
1
Flat Panel Sensors Operation Manual 897N200608
● Do not use an apparently damaged or deformed battery pack. Otherwise, the battery pack
may overheat, emit smoke, explode or ignite.
● Do not solder the battery pack directly. Otherwise, its insulator may melt, or its gas release
vent or safety mechanisms may be damaged, causing the battery pack to overheat, emit
smoke, explode or ignite.
● Do not reverse the positive (+) and negative (-) terminals. Otherwise, the battery pack may
be reverse-charged during charging. As a result, abnormal chemical reactions may occur
inside the battery pack, or extremely high current may flow during discharging, causing it to
overheat, emit smoke, explode or ignite.
● The battery pack has a predetermined polarity. If you cannot connect the battery pack to the
battery charger or other equipment, do not connect the battery pack forcefully. Make sure
that the terminals are correctly oriented. If the battery pack is connected in reverse, it will
be reverse-charged, and abnormal chemical reactions may occur inside the battery pack,
causing it to overheat, emit smoke, explode or ignite.
● Do not connect the battery pack to an electrical outlet or cigarette lighter socket in a car.
Overcurrent may flow to the battery pack due to high voltage applied, causing the battery
pack to overheat, emit smoke, explode or ignite.
● Do not use the battery pack for equipment other than those specified. Otherwise, the
guaranteed performance will be reduced and/or the service life will be shortened. Depending
on the equipment to which the battery pack is connected, extremely high current may flow,
causing the battery pack to be damaged, overheat, emit smoke, explode or ignite.
● If the electrolyte leaked from the battery pack enters the eyes, do not rub them. Wash the
eyes immediately with clean water such as tap water, and consult a doctor. Otherwise, eye
injury may result.
● Do not use the battery pack in combination with a primary battery such as a dry battery or
other battery of a different capacity, type and/or brand. Otherwise, the battery pack may
be overcharged during charging, and abnormal chemical reactions may occur inside the
battery pack, causing it to overheat, emit smoke, explode or ignite.
● Do not put the battery pack in a microwave oven or high-pressure container. Otherwise, the
battery pack may be rapidly heated or damaged, causing it to overheat, emit smoke, explode
or ignite.
● If the battery pack leaks or emits an unusual odor, remove it from fire immediately.
Otherwise, the leaked electrolyte may catch fire, causing the battery pack to overheat, emit
smoke, explode or ignite.
● If you notice an unusual odor, heat, discoloration, deformation or any other abnormality
during use, charging or storage, remove the battery pack from the equipment or battery
charger, and stop using it. Otherwise, the battery pack may overheat, emit smoke, explode
or ignite.
● Do not use the battery pack exposed to a strong magnetic field of an MRI system, etc.
● Do not use the battery pack immersed in liquid.
Other Warnings and Cautions
WARNING
No modification of this equipment is allowed.
CAUTIONS
Install the system in accordance with what is provided by IEC 60601-1:2005 + A1:2012 Chapter
16. Contact our official dealer or INNOLUX Representative for installation (except the flat panel
sensor) of the system.
CAUTIONS
Do not hit or drop the flat panel sensor. Otherwise, injury or damage to images, etc. may result.
