Inmes FF-325 PLUS, Руководство по эксплуатации

Страница: 15 / 62

INMES Industrial Ltda – Sliding table saw FF-325 Plus 13
4.3 Characteristics of the installation area (Pic. 4.3)
It is prohibited to install the machine in explosive environments.
The installation area should be selected by assessing the required workspace depending on the size of the
parts to be cut. It is also necessary to check the capacity of the floor and the surface used so that the
machine can rest equally on its entire base.
A power source and exhaust duct should be near the location of the machine which should be well lit.
Pinning to the floor:
The machine must be attached to the floor.
- Use a pin / nut A to level the feet and check that the machine is secured and allocated.
- Fix expansion pin D to the floor, use Washer / Lock washer C and hex nut. B to tighten the pins.
Note: This item does not come with the machine.
(Pic. 4.3)
4.4 Installation of moving parts
Some elements will be disassembled from the main machine frame due to packing and shipping needs.
These parts should be installed as follows.
Tighten all bolts and nuts tightly. If this is not done correctly, there is a risk that the machine will trip or
cause danger to the operator or another person.