2. Installation of Flex2R/2T
2. Installation of Flex2R/2T
Flex2R/2T does not have integrated tamper protection and exposes the cables in use to possible tampering.
It is therefore advisable to protect the connections and also the device by installing it inside an enclosure,
which can be:
l
control panel cabinet, using the appropriate holes on the back plate
l
junction box
l
electrical cabinet
l
roller-shutter enclosure
Note
In order to comply with standard 50131, the enclosure utilized as well as the device itself must be equipped with
protection.
1.
Choose a suitable mounting placement.
If the control panel cabinet is used, the control panel must be disconnected completely from both the
primary-power source (230V~) and the buffer battery.
2.
Secure the device enclosure inside the box.
If the control panel cabinet is used, secure the plastic enclosure via the threaded holes on the back
plate.
3.
Pull the wires through the cable entry and wire up the device.
4.
Install the device
protection.
5.
Enroll the device.
6.
Close the box.
7.
If the control panel cabinet is used, power up the control panel again by connecting the primary-
power source (230V~) and the buffer battery.
8
Installation and programming manual- 101
