Flex2R/2T | © 2021 Inim Electronics S.r.l.
5
1.3 Operating mode
Relative humidity
≤ 75% without condensation
Security rating
2
Environmental class
II
Dimensions (W x H x D, with flanges)
41 x 69 x 25 mm
Dimensions (W x H x D, without flanges)
41 x 49 x 25 mm
Weight
40g
(EN IEC 62368-1)
Isolation class
Terminal type
+ D S -
ES1, PS2
T1, T2
ES1, PS1
SW1, SW2
ES3, PS3
1.3 Operating mode
Flex2R/2T can operate in several modes, to be selected during the programming phase. These operating
modes can be divided into three categories:
1.
Generic home-automation module
2.
Roller-shutter module
3.
Light control module
Generic home-automation module
Default operating mode when Flex2R/2T is a control panel peripheral.
In this operating mode all 4 terminals are independent of each other and are managed completely by the
control panel.
Roller-shutter module
The terminals in use are linked to a specific function which is defined depending on the type of home-auto-
mation selected:
l
Standard roller-shutters module
Long pressing the button (i.e. pressing and holding the button) connected to terminal ‘T1’ (/ ‘T2’) will
move the roller shutter downwards (/ upwards) until it reaches the end of its down (/ up) position or
for the down (/ up) time, summed to the additional programmed time, regardless of its start position.
The roller shutter will stop when the button is released.
l
‘Smart’ roller-shutters module
In this mode the roller shutter will behave as follows:
l
Short pressing the button (i.e. pressing and releasing the button within 1 second) connected
to terminal ‘T1’ (/ ‘T2’) will move the roller shutter downwards (/upwards) in steps of a 1/4 of
the full run of the roller shutter.
l
Long pressing the button (i.e. pressing and holding the button for at least 1 second ) con-
nected to terminal ‘T1’ (/ ‘T2’) will move the roller shutter downwards (/ upwards) to the end of
