Ingeteam INGEREV RAPID 120, Инструкция по установке и эксплуатации

Страница: 75 / 248

ACA2011IQM01_ - Installation and Operation Manual
DE
EN
ES
FR
IT
PT
7. Connection of accessories
This chapter explains the process for wiring the standard and optional accessories to the unit.
Read carefully before starting the connection process.
7.1. Safety instructions for connecting accessories
DANGER
Make sure there is no voltage present on the unit before starting the connection.
Do not switch on the power to the unit until you have successfully made the rest of the connections and the unit
is closed.
Use the Personal Protective Equipment specified in section “Personal Protective Equipment (PPE)” .
CAUTION
Ingeteam accepts no liability for any damages caused by an incorrect connection.
7.2. Ethernet communication
7.2.1. Cabling requirements
For Ethernet communication, use a cable with a diameter of 4 to 6 mm.
7.2.2. Connection process
To make the connection, follow this order:
1. Introduce the Ethernet cabling through the corresponding gland in the lower cable access area.
2. Guide the cabling through the ducts as shown in the following figure.
3. Insert the RJ45 connector into the control card (located on the front door).
4. Press the cable gland to ensure it is sealed, making sure that the cabling is not taut.
75
Connection of accessories Ingeteam